product
(empty)
No products
Aluminum grommet for tubing
Aluminum grommet for tubing
Aluminum grommets for rubber tubing.
These are used so you can run one piece of tubing from the water pickup to the motor or esc in your boat. These are simple to install.
- 6.8 mm tubing
Installation note: First cut a 45 degree angle on the tubing. Then apply a thin coating of oil on the outside of the tubing. Start the tubing into the hole, then pull the tubing through the grommet from the opposite side with a pair of pliers.
Includes:
(2) Per pack
Material:
Silver anodized aluminum
Note: Picture on boat is for display only. This item only contains (2) grommets.